Artec
2.5W Artec Amp Circuit Board with Pre-wired Leads
- SKU:
- 52-002-01
- UPC:
- 608939834927
Bulk discount rates
Below are the available bulk discount rates for each individual item when you purchase a certain amount
| Buy 10 - 24 | and get $1.00 off |
| Buy 25 or above | and get $2.00 off |
Description
This is a basic 2.5W Artec amp circuit board with on-board on/off/volume potentiometer, with an included 9-volt battery connector. We include a basic sheet with wiring diagrams for this board. These make a great little amp, which can be housed in a cigar box, tin, or other small enclosure. If you are looking for more of a kit, be sure to check our our separate kit listings!
The amp board you receive will have clearly labeled 12" leads pre-soldered to the key points on the circuit board: speaker, battery, LED and input jack. All you have to do is connect the leads to your amp components and you're good to go.
You can also add a panel-mount gain pot to this circuit, if you aren't afraid of a little soldering. The video below shows how. Please note that you can damage/ruin your amp board doing this and we do not warranty any damage caused by following these steps!
Related Products
3pc. 41mm JUMBO piezos with pre-wired leads
Murata
6pc. 41mm JUMBO piezos with pre-wired leads
Murata
Cigar Box Guitar Amplifier KIT with All-wood box & Pre-wired Leads - Full How-to Video!
C. B. Gitty
"Tone Distiller" - Pre-wired Active Tone Control Knob for Guitar or Amp - Distill your Tone for the best sound!
Artec
