Electronics - Misc.

These external-mount 9-volt battery trays are perfect for custom amplifiers, cigar box guitars with pre-amps or active circuits, and other electronics usage! Simply cut a rectangular hole in the side of your box, and use the included screws to mount...

These battery holders are meant to be mounted on the exterior panel of a device (such as a guitar or cigar box amplifier), and allow a battery to be changed without having to open up the enclosure. This style allows the battery to lay flat, and requires...

THE PSYCHO KNOB KIT: It's like injecting four different boost/distortion pedals inside your guitar or amp!   FOR GUITAR:  This simple knob requires only simple soldering to place between your volume/tone knobs and the guitar jack...

This is a set of 5 nice quality red diffused 5mm (T 1 3/4) standard-brightness LEDs. They are recommended for voltages in the 2-volt range, at a current of about 20ma. These are through-hole style LEDs and they have a slight lip at the base of the lens...

This is a set of two nice metal holding clips for 9-volt batteries. They can be mounted in various ways, including gluing, screwing or even pop-riveting if you enlarge the holes a bit. these hold a standard 9-volt battery in a flat alignment to that it...

Boost those bluesy mid-range tones.  Clean-up muddy sounding pickups. Crank up the treble for leads.  The Tone Distiller gives your pickups five different personalities. This unique active tone circuit opens up many possibilities by...

This is a set of eight (8) nice metal holding clips for 9-volt batteries. They can be mounted in various ways, including gluing, screwing or even pop-riveting if you enlarge the holes a bit. these hold a standard 9-volt battery in a flat alignment to...

This is a set of 25 nice quality red diffused 5mm (T 1 3/4) standard-brightness LEDs. They are recommended for voltages in the 2-volt range, at a current of about 20ma. These are through-hole style LEDs and they have a slight lip at the base of the lens...

This is a bulk pack of 25 nice metal holding clips for 9-volt batteries. They can be mounted in various ways, including gluing, screwing or even pop-riveting if you enlarge the holes a bit. these hold a standard 9-volt battery in a flat alignment to that...

This is a bulk pack of 100 nice quality red diffused 5mm (T 1 3/4) standard-brightness LEDs. They are recommended for voltages in the 2-volt range, at a current of about 20ma. These are through-hole style LEDs and they have a slight lip at the base of...