null

Build This Scrap Wood Slide Guitar - Easy Project

Turn a hunk of scrap wood or salvaged material like this baluster into an electric 4-string slide guitar!  This project was created by Shane Speal who saw the potential of our Hard Tail Bridges and Gittybucker style pickups as a way to make fun lap steel guitars on slab boards.  

Yesterday, I got the urge to build something new, so I went into my woodshop and challenged myself to make something within one hour.  The time restriction made the project even more interesting and added an element of excitement.

Here's the demo video...

I had purchased four salvaged balusters froman architectural salvage company. They only cost me $3!

I decided to turn one of these balusters into a 4-string lap steel.  Click here for full parts list:

  • C. B. Gitty 4-string Hard Tail Bridge - $11.99 
  • Shane Speal Signature Tuners - $7.49
  • Neutrick mono guitar jack - $7.49 
  • Maple floating bridge - Kay style - $5.79 
  • A,D,G,B strings from a pack of Shane Speal Signature Guitar Strings - $7.49 
  • Plastic jack plate - $2.49 
  • Gittybucker Pickup  - $11.49
  • Gittybucker Pickup Cover - $1.99

The first thing I did was to use a C. B. Gitty Centering Ruler ($9.49) to find the center point for bridge mounting.  This ruler is a genius tool that is essential in my workshop.  Simply place it on your project, match the numbers up on each side of the ruler and bazinga, you have a centerline.

Now that I had a center line, I could mount the bridge.  These Hardtails are a delight to use.  I especially liked the 4-string model for this project because it is designed to have the strings fed through the body and up over the saddles.  Since the salvaged baluster was weakened due to age, having the strings fed through the body gave the bridge one extra anchor to hold it tight.  

I must admit, the headstock was a bit of a mess.  I used a 1" forstner bit to remove some wood from the backside where the tuners would be mounted.  This is because the wood was too thick for the tuners' shafts.  The end result is kind of ugly on the back, but that's the challenge of building something within one hour!

I drilled and mounted the tuners.  Because I didn't have a lot of room for the tuners, two of them are actually mounted at the top of the headstock.  It just adds to the quirkiness of the guitar.

The pickup was easy to mount.  Dan Sleep's "SleepTalker" pickups are so thin, you don't need to route the body for them.  Just screw 'em to the top of the body!  I drilled a small hole under the pickup for the wire, which dangles out the back of the lap steel.  I then hardwired it to the Neutrik jack and mounted the jack plate.

I chose a C. B. Gitty floating bridge as the nut because I knew I could dig some very deep string slots in it.  (They need to be deep to handle the radical angles of the headstock string pull.)  I used a cutting bit on my Dremel to cut the string slots.

Finally, I strung the beast up. The biggest challenge was positioning the nut and the string angles at the headstock.  I had to add some round head screws to act as string trees.  It's tuned to open G (GDGB) or G Minor (GDGBb)

This was a fun build that went fast. (It took longer to blog about it than to actually build it!)