Electronics

This is a stereo chrome-plated end pin/strap button jack perfect for use in guitars, cigar box guitars, and many other instrument and audio projects. This jack is intended to be mounted through the base of an electric guitar where the strap button would...

This is a six-pack of nice narrow-profile long-shaft 250KOhm pots, perfect for use as volume controls in a guitar, amp or cigar box guitar! As you can see from the photo to the left, these are narrow-profile pots with a 15mm base. The extra-long shafts...

This is a six-pack of nice narrow-profile short-shaft 250KOhm audio taper pots, perfect for use as volume controls in a guitar, amp or cigar box guitar! As you can see from the photos, these are narrow-profile pots with a 15mm base. These pots have...

This is a pack of 10 individual 20-inch (50.8cm) lengths of shielded wire, perfect for use in cigar box guitar electronics. This is a "2-conductor" wire, with a single insulated wire for the positive, and a braided bare wire for the shielding/ground. The...

This is a pack of two general-usage capacitors, rated at 0.033 microfarads. These capacitors are great for incorporating into guitar tone circuits, amplifier circuits and more! Please note that we do not include instructions or how-to along with these,...

This is a basic 3-way toggle switches with a black knob, used for selecting between different pickups on a guitar. There are seven solder lugs coming off the bottom of the switch, and a single solder lug coming off the side. Please review the wiring...

This is a two-pack of nice narrow-profile long-shaft 250KOhm pots, perfect for use as volume controls in a guitar, amp or cigar box guitar! As you can see from the photo to the left, these are narrow-profile pots with a 15mm base. The extra-long shafts...

This is four feet total of 24-gauge stranded copper hookup wire, perfect for wiring up your cigar box guitar, standard guitar or other electronics project! This pack contains two feet each of red and black 24-gauge wire (.060").  

For years in the cigar box guitar movement, people in the know have been saying that it really wasn't feasible to have a passive tone control in a piezo circuit for cigar box guitars. It turns out, it IS feasible, and now we've done it! This listing is...

This is a pack of 2 Bourns 10KOhm linear-taper potentiometers, perfect for use as tone controls in guitars, cigar box guitars, and more. These pots include a washer and nut for mounting. These are high-quality pots that will last a very long time, and...

This is a gold-plated endpin/strap button stereo jack, great for use on standard acoustic guitars as well as cigar box guitars and other instruments. This jack is mounted with 3 brass screws (included), with no nuts to tighten. This allows them to be...

A C. B. Gitty Crafter Supply Exclusive: the "Disc-o-Tone" Junior pre-wired disk piezo harness for cigar box guitars and more! This harness does not include printed instructions - be sure to check out the How-to-Install info below to get an...